If the conf.ini still has the resolutions you entered, yet the game does not run at that resolution, then I would look for an issue other than the game, such as graphics card settings. A lot of us like to set the conf.ini to read-only, but only when we are happy with all of our game settings, and want to be sure not to change anything. Note that if you do this, you will not be able to save any other changes you make in the game configuration from within the game unless you first go back and uncheck Read-Only. With the file set to read-only, IL-2 will not be able to override your setting, and should now run at the resolution you specified. Click the 'Read-Only' box so that it is checked.

Are they still what you edited to, or has the game changed them back to lower values? If they have been changed to lower values, change them back to the correct ones, then close conf.ini, then right-click on conf.ini in Windows Explorer and select Properties from the bottom of the drop-down menu. Check the resolution lines that you edited earlier. If it is still not full resolution, quit the game and open conf.ini again. Change the lines in conf.ini as described above, then run IL-2. The advice you are getting above is really the answer, although as you will have discovered by now, the file you have to edit is named conf.ini, not config.ini. I was in your position a few months ago, trying to get IL-2/BAT to run on my 2560x1440. there are numerous posts that cover in detail the config.ini file, what each entry means and actual config.ini examples that maximizes just about everything. Please do a forum search for config.ini guide. Step Three: Under the second set of configuration settings is and immediately below that are 'width=XXXX' and 'height=XXX.' Set these to your native resolution of your monitor and save the file, then close the file.įrom this point on, do not use the config panel as it will automatically change your setting back to whatever your panel has set. This is the file you can manually change, save and will be the file the game looks for its settings. Step Two: Open config.ini file, not the file titled originalconfig.ini, but the file titled config.ini. This is a precaution in case something goes horribly wrong when you begin edition it. Step One: Do a 'save as' of this file to something like originalconfig.ini. After that you can change the resolution to whatever you want. Select the compatability tab and then check the option 'Overide high DPI scaling bevavior' and hit OK. Now you are in the position to manually adjust the settings. IL-2 Sturmovik: 1946 Find the il2fb.exe file in the steam folder and right click on it and then click properties. Double click it and it will open usually with Notepad. Go into your Il-2 root directory and find the 'config.ini' file. How comfortable are you with manual editing of the config.ini file? Since the config panel was developed for the original game back in 2001, I would recommend not using it as so many things have been changed.

Il 2 sturmovik 1946 change resolution